To ride enduro in a group, keep a gap that lets each rider see the trail, wait at every junction until the rider behind sees where you turned, put an experienced sweep with tools at the back, and agree out loud that a lost rider stops, goes back to where they last saw the group and waits.
None of this is new. Trail riders worked it out long before phones, and it still works where phones do not. This guide covers the riding side. For the night-before list (route, tools, who knows your plan), use the enduro pre-ride checklist.
How much spacing in dust and on climbs
Spacing on a trail is about what you can see. If you are reading the rear tyre in front of you, you are not reading the ruts, roots and rocks that rider just went over.
In dust, drop back until the trail surface is clear again. On a dry summer day that can be a long gap, and it feels like falling behind. It is not. The rider ahead will wait at the next junction, so you lose nothing by riding in clean air. Stay on the trail while you hang back: riding wide of the dust is how new lines get cut, and the Tread Lightly principles ask riders to stay on existing trails and avoid sensitive areas.
On climbs, one rider at a time. Wait at the bottom until the rider ahead is over the top or clearly off the line. A stalled bike on a climb with another rider right behind it means two people restarting on a slope. At the top, pull off the line before you stop, so the next rider has somewhere to go.
On descents, the same gap applies for a different reason: if the rider ahead falls, you need room to stop before you reach them.
On fast forest roads, the gap can close up, as long as nobody is eating dust.
The junction rule: wait until the rider behind sees you
At every junction, the rider in front stops and waits until the rider behind has seen which way they went. Then they ride on, and the next rider does the same at the next junction. It sounds slow. In practice it costs a few seconds per turn and saves a long search for the rider who went straight on.
Trail forums give the same advice. An undated ThumperTalk trail etiquette thread (likely pre-2023) has riders waiting periodically and stopping at every turn so the rider behind is not lost.
Two details make the rule work. First, wait where you are visible from the approach, not round the corner. Second, if the trail forks with no obvious main line, wait until you see the rider behind actually take your branch.
The sweep: who rides last and what they carry
The sweep rides at the back and is never overtaken. That one rule gives the group a simple fact: when the sweep arrives, everyone is accounted for. If the sweep gets passed, nobody is watching the back any more.
Pick a sweep who rides well within themselves on the day’s terrain and who can fix things. They usually carry the group’s main tools: tyre levers and a tube or plug kit, a spare lever, chain links, a tow strap and the bigger first-aid kit. The faster riders go in front, not at the back, because a fast sweep gets bored and starts closing gaps.
Small groups are easier to keep together. Arizona’s Tread Lightly partner page suggests riding with two or three companions so someone can help after a crash or breakdown. Past six or seven bikes, split into two groups with their own lead and sweep.
Stop, go back, wait: the rule when someone goes missing
This is the rule to say out loud in the car park, because it only works if everyone follows the same version. The ThumperTalk thread boils it down to this: if you lose someone or get lost yourself, stop, return to the point where they were last seen and wait.
The rule has three parts.
- The lost rider stops. Not slows, stops. Then they ride back to the last junction where someone waited for them, or the last place they saw the group, and stay there.
- The group goes back too. The rider in front of the missing one rides back to the last place they saw them. Everyone else waits where they are. Nobody spreads out to search different trails.
- Agree on a time. If the missing rider has not appeared after an agreed time, start the plan you made before the ride, including calling for help.
Chasing is what makes it worse. A lost rider who keeps riding forward and a group that rides back looking for them can pass each other on parallel trails. For the street version of the same plan, read separated on a group ride.
What a live group map adds with one bar of signal
A shared live map shortens the waiting when there is coverage. In Ridekin, group members see each other’s live positions on the group map, and any member can send a regroup push (“Regroup at the next stop”) to pull everyone in at the next agreed stop. Both need a phone signal. With one bar, a position gets through now and then; in a dead valley, it stops updating until the phone finds coverage again.
That makes the map a helper for the rules above, never a replacement. Keep the junction rule and the stop, go back and wait rule even when everyone has the app.
SOS is the same story. In Ridekin it is a button you press yourself, it reaches your group and riders nearby who opted in, and it needs a signal. It is not an emergency service, does not call 112 or 911 and has no crash detection. If someone is hurt, call your local emergency number first.
Record the way in so the way out is not a guess
Late in the day, tired, with the light going, nobody wants to work out which of three similar fire roads leads back to the van. Start recording at the van, before the first section. Recording keeps going with the screen off and does not need a signal, so the whole loop ends up in one GPX.
Export it after the ride. Next time, load that recording as the line to follow, and the way back is a line on the map with an off-route alert, not a memory.
From the road
Picture the kind of day this is all for. Five riders, one of them new to the woods, a loop with a lot of identical forest junctions. The new rider misses a left while the rider in front is already round the bend. Because the group agreed the rule at the van, he stops, rides back 300 metres to the junction where he last saw someone, and waits. The rider ahead notices the gap at the next junction and rides back to the same spot. Ten minutes lost, not an hour.
Common mistakes
- Riding in someone’s dust to keep up. You cannot see the trail. Drop back; the junction rule means you will not be left.
- Waiting round the corner. The rider behind needs to see you from the approach, or they will ride straight on.
- A fast rider as sweep. The sweep’s job is to be last and patient, not quick.
- Searching in different directions. One lost rider becomes two. Go back to the last place seen and wait.
- Trusting the map in a dead zone. No signal, no updates. The rules still apply.